ELUGA Live P-08D

This is a notice related to a product update of ELUGA Live P-08D. Be sure to update the product to the latest version because it contains not only additional functions but also improvements in quality.

Start of update	Model	Method	Update available until	Other
September 20, 2012	ELUGA Live P-08D	Software update	September 30, 2015	N/A

Approximately 18 minutes

• The device (tablet) may freeze when it is restarted while a password is set for the screen lock.

New software is automatically downloaded and overwrites the existing software at a preset time (default time is between 2 a.m. and 4 a.m.).
Updates can also be made as desired by performing the operation below and following the instructions on the screen.
In standby, select the application list icon → " (Settings)" → "Settings" → "About tablet" → "Software Update".

Check the build number of your device (tablet) and update the software if it is not the latest version.

Before update: 09.0710
After update: 09.0719

"Home screen" → Application list icon → " (Settings)" → "Settings" → "About tablet" → "Build number"

ELUGA Live P-08D Quick Guide for Updating Software (PDF format: 630KB)

• Updates of the software can be done while keeping the Phonebook entries, camera images, mail, downloads, and other data saved to the device intact. However, please note that in some cases data cannot be protected depending on the condition of your device (malfunction, damage, water exposure, etc.). It is recommended to back up necessary data. However, take note that you cannot back up certain data such as downloaded data.
• Do not remove the battery pack while updating the software. The software may fail to update.
• Recharge the battery before updating the software. It is recommended to connect a charger cable to the device before updating.
• Software cannot be updated in the following cases:
  • Out of service area1
  • During international roaming1
  • In airplane mode1
  • When tethering is enabled
  • While updating the OS version
  • When the date and time are set incorrectly
  • When there is insufficient battery power for the software update

    1 When the device is outside the service area or during international roaming, the update is not available even when connected via Wi-Fi.

• Updating (downloading and rewriting) software may take time.
• Communications functions and other functions will not be available during the software update.
• It is recommended that you perform the software update where there is a strong signal and that you refrain from moving the device during the software update. The software update may be interrupted if the signal is weak.
• If the software has already been updated, "No update is needed." is displayed when a check for software updates is made.
• During international roaming or when outside the service area, "When docomo network is not available, or during roaming, software update is not available even if Wi-Fi is connected." will be displayed. The same applies when connected via Wi-Fi.
• Any SMS messages sent to you during the software update are stored at the SMS center.
• When the software is updated, information unique to your ELUGA Live P-08D (model, serial number, etc.) is automatically sent to the server (software update server administered by DOCOMO). DOCOMO does not use the sent information for any purpose other than the software update.
• If the software update fails, the device may no longer start up or the "Software update failed. Please visit to a shop near you." message may be displayed and no further operation may be possible. If this happens, visit a repair counter designated by DOCOMO.
• When a PIN code is set, the PIN code entry screen appears during the restart after rewriting and you are required to enter your PIN code.
• While updating the software, do not activate other applications.
• If you touch the touch panel during the calibration (adjustment) after rewriting of the software, the calibration may not be completed properly. Be careful not to touch the touch panel during rewriting.