LYNX 3D SH-03C

This is a notice related to a product update of LYNX 3D SH-03C. Be sure to update the product to the latest version because it contains not only additional functions but also improvements in quality.

Start of update	Model	Method	Update available until	Other
September 4, 2012	LYNX 3D SH-03C	Software update	September 30, 2015	N/A

Approximately 8 minutes

• If a microSDXC card is inserted, the data in the card may become corrupted.

In addition to solving the issue above, the update also includes other enhancements to make better use of your mobile phone and some specification and display changes.

New software is automatically downloaded and overwrites the existing software at a preset time (default time is between 2 a.m. and 4 a.m.).
Updates can also be made as desired by performing the operation below and following the instructions on the screen.
In standby, display "Menu" and select "Settings" → "About phone" → "Software Update".

Check the build number of your mobile phone (handset) and update the software if it is not the latest version.

Before update: 01.00.00, 01.00.03, 01.00.04, 02.00.01, 02.01.00, 02.01.01
After update: 02.01.03

Menu → "Settings" → "About phone" → "Build number"

LYNX 3D SH-03C Quick Guide for Updating Software (PDF format: 281KB)

• Do not remove the battery pack while updating the software. The software may fail to update.
• Recharge the battery before updating the software.
• Software cannot be updated in the following cases:
  
  • During a call/outside the service area
  • During international roaming
  • In Offline mode
  • While connected to a Wi-Fi network
  • While mounted via a USB connection
  • During MTP connection
  • When the date and time are set incorrectly
  • When there is insufficient battery power for the software update
  • When there is insufficient free space for the software update
• Updating (downloading and rewriting) software may take time.
• Calls cannot be made while updating the software (Voice calls can be received during downloading. However, downloading is interrupted when a voice call is received).
• It is recommended to update software in a location with a strong signal (four bars for the antenna icon) while keeping the phone stationary.
  • If the signal strength becomes weak and downloading of the software is interrupted, try updating the software again in a location with a good signal.
• If the software update fails, "Rewrite failed" appears and all operations may not be available. If this happens, visit a repair counter designated by DOCOMO.
• While the software is updated, the reception reserve alarm and recording reserve alarm are not activated. In addition, reception or recording does not start.
  • While the software is downloaded, reception or recording starts and downloading is interrupted if the reception reserve alarm or recording reserve alarm is activated.
• When a PIN code is set, the PIN code entry screen appears during the restart after rewriting and you are required to enter your PIN code.
• While updating the software, do not activate other applications.